The Lee Precision .38-55 Winchester Steel 3-Die set allows decapping, sizing, powder charging, bullet seating and crimping on the press. There is no need for a separate taper crimp die. Lubrication is required with these dies. The included Lee Precision Steel Full Length Sizer die must be lubricated before sizing and your cases must be cleaned before charging. The Powder Through Expanding Die has an expanded and flared case neck with a hollow plug which allows simultaneous case neck flaring and charging. The Bullet Seating Die has a universal free floating seating plug that works with nearly any point style bullet. Finger adjustable seating depth and a tapered end for use with automatic bullet feeders.

Lee Dies are a fantastic value. They have the most features and offer better accuracy than more expansive competitors.

You can't go wrong with LEE Dies

INCLUDES:

• Fitted Storage Box with Latching or Slip Fit Cover
• Powder Through Expanding Die
• Steel Full Length Sizing Die
• Instructions/Load Data
• Bullet Seater Die
• Powder Dipper
• Shell Holder

Features:

• Size and decap in one operation
• Machined from quality steel to exacting tolerances
• Charge powder on press through the case expander die
• Adjustable crimp die can provide taper crimp to roll crimp

NOTES:

• For further Load Data try HODGDON Powder Co.
• MUST USE LUBRICANT. FS Reloading recommends, Lee's Resizing Lube or Frankford Arsenal Case Lube Spray.

IT IS YOUR RESPONSIBILITY TO ENSURE THE SAFETY OF YOUR LOADS

FACTORS THAT WILL INCREASE PRESSURES. SOME WILL BE DANGEROUS:

• DO NOT USE more powder than recommended
• DO NOT USE a heavier bullet than recommended
• DO NOT SEAT the bullet deeper than normal
• DO NOT USE magnum primers unless using a slow burning ball powder
• Greatly oversize bullets, excessively hard bullets or cases that are too long will cause higher pressures
• High temperatures or cartridges that were stored in a hot car or trunk will produce higher pressures

WARNING:

Ammunition reloading can be dangerous if done improperly, and should not be attempted by persons not willing and able to read and follow the instructions included with each product exactly.

• Always wear safety glasses when reloading and shooting.
• Ammunition loaded with these tools should be used in modern guns, in good condition.
• Children should not be permitted to reload ammunition without strict parental supervision.
• Primers and gun powders, like gasoline and matches, can be dangerous if improperly handled or misused.
• We do not accept responsibility for ammunition loaded with these tools, as we have no control over the manufacture and storage of components or the loading procedure and techniques used.